Division is a propagation technique used for landscape plants that do not have a single stem or crown. Many plants have just one stem emerging from the ground and can not be propagated using this technique. However, there are quite a few different plants that have multiple stems emerging from the ground and can be propagated through division.
A few examples would be Hostas, Mums, Ornamental Grasses, and many perennial flowers.
Division is exactly as it sounds. You just dig up the parent plant that you intend to reproduce and quite simply divide it into many plants. Of course the size of the parent plant will determine how many times you can divide it.
If you dont care to reduce the size of the parent plant, then you would only remove a few divisions from around the edge of the parent plant. You can probably do so without actually removing the parent plant from the ground. Just scrape the ground clean around the plant so you can see exactly which sections of the parent plant you would like to remove, take a spade and force it into the ground between the parent plant and the division you are removing. Make three more cuts around the piece you are removing, completely severing the division from the parent plant, and cutting all the roots securing it in the ground. Pry the division out of the ground. Trim the roots a little if needed and replant the division in its new location.
However, if you dont mind reducing the size of the parent plant you can completely divide the parent plant into small, equal size pieces.
Early spring is a good time to propagate by division, however, late fall will work as well. Propagation by division should be done when the parent plant is either dormant, or about to break dormancy in the spring.
The dormancy season begins in the fall after the first good hard freeze, not necessarily a frost. A frost is usually not severe enough to trigger dormancy. It usually takes a good hard freeze when the temperature drops down below 32 degrees F. for a period of a few hours. Its pretty easy to determine when a good hard freeze has taken place because any leaves remaining on the trees will be crinkled and severely damaged. Many will fall to the ground the next day.
And of course once dormancy begins the plants remain dormant until spring arrives and the temperatures begin to increase. As the temperature increases the plants become active. Root activity can occur throughout the winter, anytime the soil temperature rises above 45 degrees F. The plants are not officially out of dormancy until leaves begin to appear.
Most people dont realize that nurserymen can only dig deciduous plants while they are dormant. Once a deciduous plant develops leaves in the spring, it can not safely be transplanted until late fall when it is dormant again. Digging a deciduous plant once it leafs out will immediately put the plant into shock, and likely kill it.
Evergreens are a little different. They can not be safely transplanted once new growth is established in the spring, but once that new growth hardens off later in the summer, evergreens can be transplanted. Of course, transplanting during dormancy is usually the safest bet.
Back to propagating by division. To divide a plant all you do is dig up the parent plant. The entire plant will come out of the ground in one large clump. Place this clump on a hard surface and just cut it into several pieces using a large knife or even a spade. Each division should have at least two or three sprouts or eyes. This is much easier to determine in early spring once the eyes have begun to develop, but the leaves have not yet developed.
Once you have made these divisions, just replant each division back into your garden. Keep them watered, but not soaked.
Division is a very simple form of propagation, but it is only effective with a limited number of plants. Division will not work on what would be considered the higher forms of landscape plants. If a plant has a single stem emerging from the ground, then it must be propagated by another means.
by Michael J. McGroarty